Pallet conveyor – FlexLink Configura User Manual
Page 19
Pallet Conveyor
The Pallet Conveyor tab contains pallet-handling systems. The layout and the settings on
the tab are very similar to the Customized Conveyor tab. Apart from the system settings
made at the top, the component tab is divided into six different sections: Drive Unit,
Conveyor Components, Pallets, Pallet Handling Components, Support and Guide
Rail.
In the usual way, you here customize the conveyor system from the start (see
Customized Conveyor).
To build a pallet conveyor, proceed as follows:
1. Select the desired system type at the top.
2. Do your pre-sets.
3. Build a main conveyor (the “highway”).
4. Build a separate subordinated conveyor (a “satellite”) using the divert/merge
components.
5. Place the pallet-handling components (including pallets, locating station, stop cylinder
and sensor bracket).
6. Add support and guide rails.
Below you will find further descriptions of the new components on the Pallet tab.
19
© Copyright Configura Sverige AB 2004. All rights reserved. Reproduction, copying or distribution to a third party is prohibited unless
consent in writing has been given by the owner.