FlexLink Configura - Manual (Page 22)

Enclosure System
The Enclosure System tab contains a selection of Flexlink’s aluminum profiles and
accessories for building partitions and hinged or sliding doors. The tab is divided into five
different sections: Enclosure Inserts, Low Panels, High Panels, Doors and Feet.
To build an enclosure system, proceed as follows:
1. Select the desired enclosure type at the top.
2. Place the panels. They automatically snap to each other.
3. Add a door.
4. Add the feet.
Below you will find further descriptions of the features on the Enclosure System tab.
Low/High Panels
Place a panel on the drawing surface. A second panel automatically appears. Choose left or
right side by moving the mouse pointer horizontally. Continue to move the mouse pointer
slowly vertically to decide the angle and finally click.
The panels can be stretched into desired length after being placed on the drawing surface.
The panel height (i.e. the distance from the floor to the upper edge of the panel), however,
cannot be changed at this stage.
22
© Copyright Configura Sverige AB 2004. All rights reserved. Reproduction, copying or distribution to a third party is prohibited unless
consent in writing has been given by the owner.