FlexLink Configura - Manual (Page 17)

Std Conveyor Modules
The Std Conveyor Modules tab contains Flexlink’s standard conveyor systems. The
layout and the settings on the tab are similar to the Customized Conveyor tab. Apart
from the main system and module settings made at the top, the tab is divided into five
different sections: Drive Unit, Bends, Module, Support and Guide Rail.
Instead of customizing the conveyor system from the start, here you simply pick a module
from a library with the most common standard conveyor modules (S, L, U, Z, Q and D).
To build a standard conveyor system, proceed as follows:
1. Select the desired system and module type at the top.
2. Do your pre-sets.
3. Move down to the Module heading. A picture of the selected conveyor system is
shown.
4. Click the picture and move the mouse pointer to the drawing area.
5. Click to position the conveyor.
6. Add support and guide rails.
Note:
When selecting Module Type, Module Subtype or Bend Type, the picture is updated
directly. However, when changing Motor Side the change is not visible until the module is
actually placed on the drawing surface. At this stage, supports and guide rails have to be
put out in the usual way.
17
© Copyright Configura Sverige AB 2004. All rights reserved. Reproduction, copying or distribution to a third party is prohibited unless
consent in writing has been given by the owner.