Brooks Instrument MT3809G - Manual (Page 31)

Installation and Operation Manual
X-VA-MT3809G-MT3810G-eng
Part Number: 541B182AAG
September, 2013
Models MT3809G & MT3810G
2-1
Section 2 Installation
2-1 General
This section contains the procedures for the receipt and installation of the
instrument. Do not attempt to start the system until the instrument has
been permanently installed. It is extremely important that the start-up
procedures be followed in the exact sequence presented.
2-2 Receipt of Equipment
When the equipment is received, the outside packing case should be
checked for damage incurred during shipment. If the packing case is
damaged, the local carrier should be notified at once regarding his liability.
A report should be submitted to your nearest Product Service Department.
Brooks Instrument
407 W. Vine Street
P.O. Box 903
Hatfield, PA 19440 USA
Toll Free (888) 554-FLOW (3569)
Tel (215) 362-3700
Fax (215) 362-3745
E-mail: [email protected]
www.BrooksInstrument.com
Brooks Instrument Brooks Instrument
Neonstraat 3 1-4-4 Kitasuna Koto-Ku
6718 WX Ede, Netherlands Tokyo, 136-0073 Japan
P.O. Box 428 Tel 011-81-3-5633-7100
710 BK Ede, Netherlands Fax 011-81-3-5633-7101
Tel 31-318-549-300 E-mail:[email protected]
Fax 31-318-549-309
E-mail: [email protected]
Remove the envelope containing the packing list. Carefully remove the
instrument from the packing case. Make sure spare parts are not
discarded with the packing materials. Inspect for damaged or missing
parts.
2-3 Recommended Storage Practices
If intermediate or long-term storage is required for equipment, as supplied
by Brooks Instrument, it is recommended that the equipment be stored in
accordance with the following:
a. Within the original shipping container.
b. Stored in a sheltered area, preferably a warm, dry, heated warehouse.
c. Ambient temperature of 21°C (70°F) nominal, 43°C (110°F) maximum,
7°C (45°F) minimum.
d. Relative humidity 45% nominal, 60% maximum, 25% minimum.
Upon removal from storage, a visual inspection should be conducted to
verify the condition of equipment is "as received".