Starting self-optimization, Canceling self-optimization – Burkert Type 1150 User Manual
Page 90
88 - 1150
O
PTIMIZATION
Starting self-optimization
Start at the operating level
Select the controller channel in
/ Operation level / Self-optimization / Controller number 1 to 4
Start self-optimization for the selected controller channel with
/ Status / „Active“
Start from the operating loop
Change the screen template for the required controller channel with
(press repeatedly, if
necessary!)
Press
Press
Start self-optimization for the required controller channel with
Pressing
resets the significance of the softkeys.
The controller outputs types have to be defined for self-optimization. They also have to be
enabled for the corresponding controller channel for self-optimization to start.
(see Chapter „
Controller“).
NOTE
Canceling self-optimization
Switch the “Status” parameter at the operating level to “inactive” or press
again.