Burkert Type 8045 - Manual (Page 44)

40
Operatingandfunctions
8.6.8. configuring the transistor output Do1 to switch a load
depending on two threshold values
OUtPUt DO1 hYstEREs.
DO2
1-= 0.000
1+= 0.000
→
Enter a flow rate value 1) , associated to the high
threshold, in the unit chosen in the "UNIT" parameter.
→
Confirm.
wiNDOw
→
Enter a flow rate value 1) , associated to the low
threshold, in the unit chosen in the "UNIT" parameter.
→
Confirm.
iNV YEs
iNV NO
0......9
→
Choose the operating, inverted or not inverted, of the
transistor output.
DEL. 1= 00
→
Enter the time delay before switching value (value
between 0 and 99 s).
→
Confirm.
REtURN
On a version WITH relay out-
puts
On a version WITHOUT relay
outputs
1) If hysteresis operating: value set for 1- ≤ value set for 1+. If window switching: value set for 1- < value set for
1+.
Fig. 35: Configuration of the DO1 transistor output with switching thresholds
English
Type 8045