Vicon command summary – American Dynamics RAS916WLS User Manual
Page 102
Vicon Command Summary
The following table lists the Vicon controller key sequence to control the indicated SpeedDome Ultra
VII functions.
If you want to …
Use …
Set Auto Iris ON/OFF
(LED indicates Auto Iris state: ON = AUTO)
A/I Toggles state
Set Auto Focus ON/OFF
(LED indicates Auto Focus state: ON = AUTO)
Press and Hold L-Spd
A/P Toggles state
Goto Presets
Run/Pgm switch to RUN
Enter 1-79 Enter
Program Presets
Run/Pgm switch to PGM
Enter 1-79 Enter
Run PEEL Pattern and Repeat
AUX5
Rotate dome 180° (“Flip”)
AUX6
Start Pattern 1-3 Definition
Run/Pgm switch to PGM
Enter 80-82 Enter
End Pattern Definition
Run/Pgm switch to PGM
Enter 86 Enter
Review Pattern
Run/Pgm switch to PGM
Enter 87 Enter
Accept Pattern
Run/Pgm switch to PGM
Enter 88 Enter
Run Pattern 1-3
Run/Pgm switch to RUN
Enter 80-82 Enter
Repeat Pattern 1-3
Run/Pgm switch to RUN
Enter 83-85 Enter
Set Pattern to Peel
Enter 89 Enter
Vphase Dome
Note: The A/I LED blinks indicating that you are in the vphase
mode. Enter key sequence again to turn vphase adjustment off.
The A/I LED stops blinking and indicates Auto Iris State.
Run/Pgm switch to PGM
Enter 93 Enter
•
Pan Right to increment
•
Pan Left to decrement
Start Dome Configuration Menu
See Operating the Dome Configuration Menu on page F–3.
Enter 94 Enter
Turn IR Mode On
Run/Pgm switch to PGM
Enter 95 Enter
Turn IR Mode Off
Run/Pgm switch to PGM
Enter 96 Enter
Reset Dome
Run/Pgm switch to PGM
Enter 97 Enter
F–2
SpeedDome Ultra VII Operator's Manual