American Dynamics RAS916WLS - Manual (Page 96)

Command Summary
The following table lists the commands to operate the configuration utility when the dome is installed
in an AD Up-the-Coax (AD-UTC) environment. The keyboard must be in programming mode to
perform these functions.
If you want to … Use …
Start the configuration utility.
F
, +
(Function, and then
Shift+Menu)
Move the highlight bar on the active menu. Use the Joystick
(Pan/Tilt)
Select the highlighted item on the active menu.
or
(Focus Far or Focus Near)
Increase the value of the selected setting.
For example, Red or Blue white balance values.
(Zoom In) or
Twist joystick clockwise
Decrease the value of the selected field. For example, Red or
Blue white balance values.
(Zoom Out) or
Twist joystick counter-clockwise
Display the next choice for the setting. For example,
Maximum Zoom setting.
(Zoom In)
Display the previous choice for the setting. For example,
Maximum Zoom setting.
(Zoom Out)
Save changes and exit the utility from any screen.
F
, +
(Function, and then
Shift+Clear)
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available characters in
the selected languages. In these situations, the following commands are used:
If you want to … Use …
Move the highlight left or right in the character field. Joystick Left/Right
Move the highlight up or down in the character field. Joystick Tilt Up/Down
Select the highlighted character in the character field.
or
(Focus Far or Focus Near)
Move the cursor to the right of the current character in the
name or password.
(Zoom In) or
Twist joystick clockwise
Move the cursor to the left of the current character in the
name.
(Zoom Out) or
Twist joystick counter-clockwise
E–2 SpeedDome Ultra VII Operator's Manual