GeneralAire ERV 3220 - Manual (Page 6)

Installation Kit
Included in the installation kit:
• 4 Collars
• 2 Flexible Vinyl Ducts
• 1 Condensation Drain Line
• 1 Drain Adapter with Nut
• 4 Tie Wraps (30”)
• 16 screws (#10 x 5/8")
• 4 screws (#10 x 1")
• 4 Washers
TIPS
to installer
Removing the core unit will facilitate
your job.
Figure 3.1 Pull out the inserts first then use the straps to lift the unit out of the box.
3. GeneralAire HRV/ERV systems
4. Finding a suitable installation area for HRV or ERV
Figure 3.2 Installation kit is shipped inside the unit. Figure 3.3 Installation kit.
The HRV or ERV units should be installed in a mechanical room or as close to an outside
wall as possible. This would assure a short run of insulated flexible duct.
The HRV or ERV unit must always be installed in an area where the air is tempered to avoid
freezing of the condensate line. The contractor should install the unit in area that is very
accessible to allow the homeowner easy access for maintenance.
It is very important to install an electric receptacle (115v) near the HRV or ERV, a separate
circuit breaker is also recommended. You should have access to a condensate drain near
the HRV or ERV to avoid the use of condensate pump.
INSTALLATION
GUIDE
6