Hydrotech 1240 Series ADVANCED REVERSE OSMOSIS WATER TREATMENT SYSTEMS - Manual (Page 10)

4
FIGURE 4: Drain Hole Location and Installation, Air Gap Faucet
1. Select a location for drain hole based on type of sink and
orientation of drain line (Figure 4).
NOTE: item callouts refer to Figure 5 unless noted otherwise.
2. Position drain outlet saddle (item 1) on drainpipe. Allow
adequate space for drilling operation.
3. Tighten saddle bolts evenly on both sides. Avoid over-tightening.
4. Using opening in drain saddle outlet as a guide, drill a 3/8” to
7/16” diameter hole in drainpipe. Clean any debris out of drain
saddle connection.
ITEM DESCRIPTION PART NO.
1 Drain Saddle, Air Gap, 3/8” Connection 92160
FIGURE 5: drain outlet Assembly
Installation of Ball Valve Assembly on Plastic Storage Tank
The ball valve and quick connect adapter must be installed on the
ro storage tank.
a. Install the 1/4” x 3/8” male connector onto the ball valve.
IMPORTANT– Make sure to install the ‘INSERT’ in the 3/8” tubing
before tightening the nut of the ball valve.
Tighten the fitting very gently until it is snug. Be very careful not to
over-tighten or the threads may strip.
b. Tighten the ball valve assembly onto the ro storage tank.
Tighten the fitting very gently until it is snug. Be very careful not to
over-tighten or the threads may strip.
DRAIN OUTLET ASSEMBLY INSTALLATION
NOTE: State, provincial and local plumbing codes may prohibit use of saddle-tapping drain connections and may require use of
an air gap.
NOTE: location and orientation of drain outlet assembly is vital to system performance.
Horizontal Drain Line:
locate drain hole as close as possible to top of pipe
(between 45º and top) and as far as practical from
garbage disposal.
Vertical Drain Line:
locate drain hole on a straight length of
drainpipe next to “P”/”S” trap between
trap and sink.
INSTALL HERE
DO NOT INSTALL HERE
MAXIMUM DISPLACEMENT
FROM TOP CENTER - 45°
DISPOSAL
SINk SINk
DRAIN LINE
FROM AIR GAP
(AIR GAP ONLy)
VERTICAL
MOUNT
HORIZONTAL
MOUNT
1
DRAINPIPE
ADAPTER
INSERT
BALL VALVE
3/8”
TUBING
TANk