CAME BX-P Kit - Manual (Page 2)

2
A
ll t
h
e d
at
a a
n
d i
n
fo
rm
at
io
n c
o
n
ta
in
ed h
er
ei
n
i
s c
o
n
si
d
er
ed
s
u
b
je
ct to c
h
an
g
e a
t a
n
y t
im
e a
n
d a
t o
u
r d
is
cr
et
io
n
ENGLISH
2.1 Destination
1 Legend
2 Destination and limits of use
The BX-P gearmotor is designed to automate sliding gates for residential and condominium complexes.
The use of this product for purposes other than the one intended and installation carried out in a manner other than as
instructed in this technical manual are prohibited.
2.2 Limits of use
For intensive or condominium use: maximum gate weight 600 kg with maximum length of 14 meters.
—#
—#
This symbol indicates sections to be read with particular care.
This symbol indicates sections concernig safety
This symbol indicates notes to communicate to users.
“IMPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION”
“CAUTION: IMPROPER INSTALLATION MAY CAUSE SERIOUS DAMAGE, FOLLOW ALL INSTALLATION INSTRUCTIONS CAREFULLY”
“THIS MANUAL IS ONLY FOR PROFESSIONAL INSTALLERS OR QUALIFIED PERSONS”
The following standard were complied with for this product: EN 12978, UNI EN 954-1, CEI EN 60335-1, UNI EN 12453.
3 Standard followed
4.1 Gearmotor
The BX-P ratiomotor is designed and built by CAME CANCELLI AUTOMATICI S.p.A. and it meets the safety standards in force.
Guaranteed 24 months if not tampered with.
The case consists partly of cast aluminium, inside of which operates the non-reversible electromechanical gearmotor, and partly
of a covering in ABS plastic inside of which is an electronic card, the transformer and the emergency battery holder.
The BX-P ratiomotor may be supplied with complementary accessories such as:
001 R001 - Lock cylinder with DIN keys;
001 BSF - Braking device for gates installed on a sloping surface;
001 BRC5/10/15 - Power supply cable winding device for sensitive safety profi les;
001 B4337 - Chain transmission device;
009 CGZ - Galvanized steel 22 x 22 module 4 rack;
009 CGZF - PA 6 nylon 20 x 30 module 4 rack with holes and fi xing spacers;
009 CGZS - Galvanized steel 30 x 8 module 4 rack with fastening screws, holes and supports;
009 CCT - Simple 1/2” chain;
009 CGIU - 1/2” chain joint.
Important! Check that the safety equipment and accessories are CAME originals; this is a guarantee that also makes the system
easy to set up and upkeep.
4 Description
4.2 Technical information
GEARMOTOR
Power supply: 230V A.C. 50/60Hz
Motor power supply: 230V A.C. 50/60Hz
Max. absorption: 2 A
Rated power: 230 W
Max. torque: *27 Nm
Reduction ratio: 1/10.5
Push: 600 N Max. speed: 17 m/min
Operation intermittence: 30%
Protection level: IP54
Weight: 15 kg
Condenser: 31.5 µF
Engine thermoprotection: 150° C
Operating temperature:
* Obtained with CAME control panel.