CAME BX-P Kit - Manual (Page 8)

,).%
/.
         
% "/!2$
#/.42/,
:"8
!&
!&
#(
5 6 7 % , .     0  # # %" %" ,4 ,4 #4    &! &# & " "
#(
!&
13
5
12
14
1
3
2
16
7 8 6 15 17
10
11
White Red
4
18
9

Black
Orange
Violet Blue
6.1 Technical description board
6.2 Main components
1 - Power supply and transformer connection terminal board
2 - 5A line fuse
3 - 1A accessory fuse
4 - Dip-switch "selezione funzioni"
5 - Radiofrequency board coupling for remote control
6 - Trimmer A.C.: automatic closing time adjustment
7 - Trimmer PAR.OP.: partial aperture adjustment
8 - Save button of the radio-codes of the remote control
9 - LED signalling the radio-code of the remote control
10 - Terminal board for battery charge connection
11 - Coupling radio-frequency board for the “pratico system”
12 - 1.6A battery fuse
13 - 630mA control unit fuse
14 - 1.6A electric block fuse
15 - LED 230V power-supply signal
16 - Terminal boards connecting the electrical lock, end stop and accessories
17 -LED signalling the radio-code of the “pratico system”
18 - Save button of the radio-code of the “pratico system”
6 Control board
This control board is powered by 230V a.c. across terminals L and N, and is protected by a 5A fuse on the main power line.
Control systems are powered by low voltage and protected with by a 1A fuse.
The total power consumption of 24V accessories must not exceed 40 W.
Photoelectric cells may be connected and set for reopening during closure, partial stop, total stop and detection of an obstacle
with the motor turned off.
Note: if a usually closed safety contact (2-C1, 2-C3 or 1-2) is opened, it is signalled by the fl ashing of the LED indicator (ref. part
9, main components).
The board also incorporates other features that can be selected: Automatic closure, partial opening, pre-fl ashing opening and
closing, “maintained action” operations and type of command: Open-stop-close-stop, Open-close-invert, or opening only.
Option to connect a cycle lamp. A lamp lights up the manoeuvring zone, it remains lit from the moment the doors begin to open
until they are completely closed (including the time required for the automatic closure).
Possibility to adjust the automatic closing time, the operating time and partial opening*.
*( see parag. 6.7 Adjustments)
Important! - Shut off the mains power and disconnect the batteries before servicing the inside of the unit.
8
A
ll t
h
e d
at
a a
n
d i
n
fo
rm
at
io
n c
o
n
ta
in
ed h
er
ei
n
i
s c
o
n
si
d
er
ed
s
u
b
je
ct to c
h
an
g
e a
t a
n
y t
im
e a
n
d a
t o
u
r d
is
cr
et
io
n
ENGLISH