Alto-Shaam 1200-TH/III - Manual (Page 15)

Preset Menu Keys:
Alto-Shaam Cook and Hold ovens allow the operator to set up to eight cooking programs. Each cooking program
can be preset in any program mode to cook by time or internal product temperature. Cooking programs are
recalled and stored using the PRESET keys labeled "A through H." These keys, along with the key labeled "I"
share additional functions described in the "User Options" section of this manual.
Programming a Cooking Program
Prior to this procedure, make sure the oven is “OFF”. Select the food product to be programmed.
Press and release control ON/OFF key. The oven will beep for one second and power to the unit
will be indicated by an illuminated green indicator light located in the upper left corner of the
ON/OFF key. The oven will begin operating in the hold mode. The amber hold indicator will be
illuminated and the last set hold temperature will be displayed.
Press HOLD key. To change the hold temperature, press the UP or DOWN
ARROW keys.
Press COOK key. Oven preheat indicator will illuminate and the last set cooking temperature
is displayed. To change the cook temperature, press the UP or DOWN ARROW keys.
To cook by time — press the TIME key. Last set cooking time is displayed.
To change the set time, press the UP or DOWN ARROW keys. The green Time
indicator will illuminate.
To cook by probe — press the PROBE key. Last set internal product temperature is displayed.
To change the set temperature, press the UP or DOWN ARROW keys. The green Probe indicator
will illuminate.
The oven preheat indicator will illuminate. Oven is now in the preheat mode and is
automatically programmed to preheat to the cook temperature.
Select a letter code for the product programmed by the previous steps. Press and hold the
selected PRESET key until you hear a brief, four second beep. The letter key program indicator
light will illuminate and the product programmed is now stored in memory for the specific letter
key pressed. Additional programs can be stored in the remaining PRESET keys if not previously
programmed.
Note: The last PRESET key used will be the oven cooking run sequence for the next product
to be programmed. Settings can be manually changed for the next product and an alternate
pre-programmed letter key selected.
Erasing a Cooking Program
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a Preset Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold both the CANCEL key and
the appropriate letter PRESET key to be erased. Hold both keys until the oven beeps and the program's indicator
light goes out to indicate the program has been erased.
—
or
—
PRESETS A
After programming a specific product into memory in a programmable preset key,
it is very important to make a written permanent record of the product and the program letter
assigned. Menu card
(PE-23384)
is provided for this purpose.
IMPORTANT
O P E R A T I N G I N S T R U C T I O N S
PG . 14 TH/III INSTALLATION / OPERATION / SERVICE MANUAL