Belt clip, Beltpack bottom connector section, Data connector – Clear-Com FreeSpeak Beltpack User Manual
Page 24: Headset connector, Battery recharger connector, Belt clip -6, Beltpack bottom connector section -6, Data connector -6, Headset connector -6, Battery recharger connector -6
Clear-Com Communication Systems
Eclipse Wireless Communication System
1 - 6
Belt Clip
The belt clip is spring-loaded, with enough tension to hold the beltpack
to the user’s belt and against the hip. Note that the upper portion of the
rear of the beltpack, connected to the belt clip, is a separate piece; the
entire belt clip assembly may be replaced in case of damage.
BELTPACK BOTTOM CONNECTOR SECTION
Figure 1-6: View of Bottom of Beltpack
Data Connector
This 3.5 mm (1/8 inch) tip-ring-sleeve (TRS) connector is used to
connect the beltpack to a computer in order to identify the beltpack to
the matrix during initial registration and system setup. It may also be
used if an upgrade to the beltpack firmware is ever required in the
future, to add new features and capabilities. See the section
“Registering the Beltpack with the Matrix” for further details.
Headset Connector
The male 4-pin headset connector provides audio pathways for the
headset microphone and headset earpiece(s). This connector
supports all Clear-Com and compatible headsets using female 4-pin
connectors. It will support dynamic microphones.
Battery Recharger Connector
The Eclipse beltpack features an internal battery charger when you
insert four AA-format NiMH batteries to power the unit. The recharger
circuit includes a thermistor that senses the temperature of the battery
3
1
2
3