Quickstart guide – Clear-Com Tempest2400 User Manual

Page 3

Advertising
background image

6

8

9

●

Slide the battery door off by pressing down and back.

●

Install the battery or (3) AA batteries and replace the battery door.

●

Press and hold the ON/OFF button for two seconds; the BeltStation
will vibrate as it powers up.

●

Power the BeltStation OFF by pressing and holding the ON/OFF
button for four seconds.

●

Plug a headset into each BeltStation.

●

To set Mic Gain, Press MENU and scroll down to Set Controls.

●

Scroll to Mic Gain and Press ENTER.

●

Set the Mic Gain for the headset that you are using; speak loudly into the
microphone and adjust the setting so that the blue TALK LED starts to flash
red. Press ENTER to save.

●

Select the desired communication channel by pressing the A or B channel
selector.

●

Adjust the headset listening volume by turning the A or B rotary control.

●

Press the TALK button to talk to others on the selected channel (the blue
flashing LED will remain lit when talk is enabled on that channel)*

●

Confirm the desired talk channel and talk status by observing the BeltStation
LCD screen.

●

Select the correct intercom type on the front of the BaseStation

» Intercom type select switch A&B controls both intercom channels A and

B.

» CLEAR-COM is used for Clear-Com and Clear-Com compatible 2-Wire

systems.

» RTS is used for RTS and RTS compatible systems.
» BAL is used for Telex AudioCom & AudioCom compatible systems.

●

Connect 3-PIN XLR cables to the back of the BaseStation for the appropriate
channel.

●

Press the left SEL button to select an intercom channel (A or B); press the
right SEL button to select 2-Wire operation.

●

Use the IN and OUT rotary controls to set the IN (from 2-Wire to BaseStation
and OUT (from BaseStation to 2-Wire) levels.

●

Perform Auto Null from the BaseStation*

●

Connect RJ-45 cables to the back of the BaseStation for the appropriate
channel.

Note: The intercom type select switches do not apply to 4-Wire

operation.*

●

Press the left SEL button to select an intercom channel (A or B).

●

Press the right SEL button to select 4-Wire operation.

●

Use the IN and OUT rotary controls to set the IN (from 4-Wire to BaseStation
and OUT (from BaseStation to 4-Wire) levels.

*Refer to the Tempest Owner’s Manual for detailed system information.

Power ON the BeltStation

Pair BeltStations to the BaseStations

Start Communicating

Connecting to External 2-wire

Intercom Systems

Connecting to External 4-wire

Intercom Systems

2 sec

POWER ON

●

Confirm the BaseStation is powered ON.

●

Confirm the BeltStation is powered OFF.

●

Connect the 3.5mm data pairing cable from the BaseStation to the BeltStation.

●

Power ON the BeltStation while observing the BeltStation LCD screen; the
BeltStation will vibrate and “Pairing Complete” will appear momentarily on the LCD
screen if pairing was successfull.

●

The BeltStation will return to the operational screen and log into the BaseStation.

●

The BeltStation will appear in the first available slot on the LCD screen.

●

Repeat for each BeltStation.

Note: BeltStations are named to their default setting name. They can be renamed.

QuickStart Guide

7

5

Advertising