Clear-Com BS200 - Manual (Page 12)

BASE STATION SETUP
The following description is for a basic, stand-alone DX200 system setup.
Connections and setup for multiple, daisy-chained base stations are described on pages 8 – 10.
Connections with 2-wire and 4-wire intercoms, and other auxiliary equipment are described in the INTERCOM
AND AUXILIARY EQUIPMENT SETUPS on pages 20 and 21.
Equipment Connections
31 32 36 37
Rear Panel
1 3 17 15
Front Panel
Step 1. Connect the two enclosed antennas to the antenna connectors (#31 and #32) on the rear panel of the base
station. Position the antenna at the 0° ANTENNA connector (#31) vertically. Position the antenna at the
90° ANTENNA connector (#32) horizontally, pointing to the left as indicated on the panel. Turn the sleeve
on each of the antenna connectors clockwise to tighten them securely in place.
Step 2. Plug the connector at the end of the AC power supply cord into the 12-14VDC power connector (#36) on
the rear panel of the base station. Turn the nut on the cable connector clockwise to secure it to the base
station. Plug the large female connector at one end of the AC power cord into the power supply. Plug the
other end of the AC power cord into an electrical outlet.
Step 3. Connect a grounding wire from #37 to an earth ground.
Step 4. Plug a headset into the HEADSET connector (#15) on the front panel of the base station.
Step 5. Press the POWER switch (#1) to turn on the base station. The red light on the switch should go on.
7