Clear-Com BS200 - Manual (Page 16)

BELTPAC / WH200 HEADSET / SPEAKER STATION
SETUP AND REGISTRATION
The first time you operate the DX200 system, you must register each Beltpac, WH200 Headset and/or WS200
Speaker Station for use with a specific base station. The base station will then recognize all registered
Beltpacs/Headsets/Speaker Stations when their power is on, and will know the difference between them and
other electronic equipment operating on the same frequencies. If a Beltpac/Headset/Speaker Station is added,
replaced or repaired later, the new one must be registered and the old one remains in memory. A maximum of
15 Beltpacs and/or Headsets and/or Speaker Stations can be registered to a single base station at one time. If
the maximum number of 15 is exceeded, you must clear all current registrations and re-register all active
Beltpacs/Headsets/ Speaker Stations.
NOTE: The following two pages are for Beltpac setup and registration. WH200 Headset setup and
registration instructions are on pages 13 and 14. Instructions for WS200 Speaker Station setup and
registration are on pages 15 - 18.
Set Up Beltpacs
11
17
3
Before registering them, set up all Beltpacs as follows. Step 3 Step 2
Step 1. Insert a fully charged battery in the
Beltpac, with the metal contacts on
the end of the battery inserted first.
Press it in until it snaps.
Step 1
Step 2. Place the Beltpac in the pouch.
Step 3. Plug the headset cable connector into the Beltpac.
Register Beltpacs
Beltpacs must be within 6 feet (1.83 meters) of the base station while you are registering them. Be certain the
base station power is on, and each Beltpac you are going to register is turned off before you begin. Beltpacs that
are already registered can be on or off.
NOTE: If you are setting up multiple, daisy-chained base stations, the following steps must be repeated for
Beltpacs being registered to each base station.
Step 1. Put the headset, of the Beltpac being registered, on your head.
Step 2. Press the REGISTER button on the front panel of the
base station (#17 on base station front panel illustration).
• The STATUS display (#3 on base station front
panel illustration) will show a small “o” for open.
NOTE: If you wait too long before going on to Step 3,
the base station will go out of the registration
mode and you will have to repeat Step 2.
Step 3. Press and hold the ISO button on the Beltpac while you press and
release the PWR (power) button to turn the unit on, then release the
ISO button. This will cause the Beltpac to enter the registration mode.
• The two power lights at the corners of the Beltpac near the IC
and ISO buttons will begin blinking red, then will blink green
two or three times and go off.
•
Wait! There may be a short delay.