Hach-Lange 3705 sc - Manual (Page 17)

15
Section 4 Operation
4.1 Using the sc Controller
Before using the sensor in combination with an sc controller make yourself familiar with
the operating mode of the controller. Refer to the controller user manual and learn how to
use and navigate the menu functions.
4.2 Sensor Setup
When a sensor is initially installed, the serial number of the sensor will be displayed as the
sensor name. To change the sensor name refer to the following instructions:
1. Select the Main Menu.
2. From the Main Menu, select SENSOR SETUP and confirm.
3. Select the appropriate sensor if more than one sensor is attached and confirm.
4. Select CONFIGURE and confirm.
5. Select EDIT NAME and edit the name. Confirm or cancel to return to the Sensor
Setup menu.
4.3 Sensor Data Logging
The sc controller provides one data log and one event log for each sensor. The data log
stores the measurement data at selected intervals. The event log stores a variety of events
that occur on the devices such as configuration changes, alarms, warning conditions, etc.
The data log and the event log can be read out in a CSV format. For downloading the logs
please refer to the controller user manual.
4.4 Sensor Status Menu
SELECT SENSOR
ERROR LIST—See section 6.1 on page 25 .
WARNING LIST—See section 6.2 on page 25 .
4.5 Sensor Setup Menu
CALIBRATE
SELECT SENSOR (if more than one sensor is attached)
ZERO
Perform a zero cal to remove sensor offset.
SAMPLE CAL
Perform a single point calibration.
COND CAL
After setting the reference temperature and slope, conduct a single-point calibration of the conductivity sensor.
TEMP ADJUST
Adjust the displayed temperature by up to ±15 °C.
DEFAULT SETUP