Operation, 3 entering values into the configuring tds table – Hach-Lange 3705 sc User Manual
Page 24
22
Operation
5.
Select SELECT TYPE. Select USER DEFINED or BUILT-IN and confirm.
If USER DEFINED is selected:
a.
Select CONFIG TABLE and confirm.
b. Confirm again to edit the points.
If BUILT-IN is selected:
a.
Choose from the list of built-in tables.
4.8.3 Entering Values into the Configuring TDS Table
If TDS has been selected in the Select Measure menu, the user may choose to enter
values into the user defined table as follows:
1.
From the Main Menu, select SENSOR SETUP and confirm.
2.
Highlight the appropriate sensor if more than one sensor is attached and confirm.
3.
Select SELECT MEASURE and change to Conc and confirm.
4.
Select CONFIG TDS and confirm.
5.
Select SELECT FACTOR and confirm.
6.
Choose NaCl or USER DEFINED. If NaCl is selected, not other configuration is
necessary.
If USER DEFINED is selected:
a.
Select SET FACTOR and confirm.
b. Enter the value.