Hach-Lange 3798-S sc - Manual (Page 18)

16
Operation
5.5 The commands under SENSOR SETUP
SENSOR SETUP
SELECT SENSOR (for several sensors)
CALIBRATE
ZERO CAL
Eliminates sensor offset
See
5.6.1 "Calibration in air (ZERO CAL)" .
ELECTRIC. SPAN
Calibration with a defined resistance.
See
5.6.2 "Calibration in air (ELECTRIC. SPAN)" .
PROCESS SPAN
Calibration with a reference solution.
See
5.6.3 "Calibration in the process (PROCESS SPAN)" .
PROCESS TEMP
Calibration of the temperature.
See
5.7 "Adjusting the Temperature" .
CAL CONFIG
OUTPUT_MODE
Choose between:
ACTIVE, output signal follows the input signal;
HOLD, last measured value and output signal are held;
TRANSFER, fixed value is output to the peripherals; and
CHOICE
CAL REMINDER
You can set when the next calibration is to be performed. The
controller then automatically indicates when the next calibration is due.
CORR FACTORS
Choose between
TEMP OFFSET,
GAIN CORR and
GAIN VALUE,
SET CAL DEFLT Return to the factory settings after prompt for confirmation.
CONFIGURE
EDIT NAME Enter a 10-character name.
PARAMETERS Choose a parameter.
DEGREES C-F Choose between degrees Celsius or Fahrenheit.
T-COMPENSATION Choose between LINEAR and NONE.
T-SENSOR
AUTOMATIC
MANUAL
Enter a value.
FILTER Enter a value.
LOG. DELAY
LOG INTERVAL Choose between the values available or DISABLED.
TEMP INTERVAL Choose between the values available or DISABLED.
MAINS FREQ. Enter the mains frequency.
SET DEFAULTS Returns to the factory settings after a prompt for confirmation.
DIAG/TEST
PROBE INFO Provides information on driver, software and serial number
CAL DATA Provides information on GAIN, Offset (T) and GAIN CORR.
SIGNALS Provides information on raw data measured.
COUNTERS Provides information on the operating time since the last calibration
TEST/MAINT Disable OUTPUT during test or maintenance
SERVICE Reset Service Counter