Hach-Lange DR2800 eco - Manual (Page 21)

21
Installation
3.6.1 Position the Protective Cover
1. After you have inserted the zero solution cuvette or the sample
cuvette, position the Protective Cover over the open cuvette
compartment. The lettering "Protective Cover" must be
readable from the display side of the instrument.
2. Press the Protective Cover lightly into the correct position until
the cuvette compartment is completely sealed and the
Protective Cover cannot slip off.
3. Carry out the measurement.
Note: The Protective Cover can simultaneously be used to house the
different cuvette adapters. The cuvette adapter recesses in the Protective
Cover are marked with the corresponding letters and arrows of the adapter.
The arrows in the Protective Cover and on the adapters indicate the
direction of insertion.
Figure 8 Position the Protective Cover