INSTEON Keypad Dimmer (Dual-Band) (2334-2xx US) Manual - Manual (Page 18)

Page 18 of 24 Rev: 7/25/2013 9:16 AM
Changing Buttons
Keypad buttons can be swapped out with custom-etched buttons to customize its
appearance. Using a small, flat-edged screwdriver only, carefully pry up on the sides
of the keys from the middle of the keypad (when possible). Make sure you are
centered on the key so as to catch the small edge located there for this purpose.
Please note that behind the buttons are clear plastic filler pieces; these diffuse the
buttons’ LEDs’ lights more elegantly. Use care to keep these filler pieces in the button
frame as you reassemble the keypad.
Should any damage occur to Keypad during customization, please contact 800-762-7845 and we will be happy to replace
your frame.
Advanced Features
Local Ramp-Rate
The local ramp rate is the time it takes for the light(s) physically wired to Keypad to brighten from off to 100% brightness.
The default ramp rate is 0.5 seconds, but it can be set to different rates. When set manually, it can be set from 0.1 to 9
seconds. However, when using home-management software such as HouseLinc, the ramp rate may be configured
anywhere from 0.1 seconds to 8 minutes. Follow the instructions below to manually change the local ramp rate.
1) Adjust the connected light(s) to brightness corresponding to the desired ramp rate
Brightness Level Ramp Rate in Seconds
90-100% 0.1
77-87% 0.2
65-74% 0.3
52-61% 2.0
39-48% 2.0
26-35% 4.5
13-23% 6.5
1-10% 8.5
1% 9.0
2) Double-tap the Set button on your Keypad
Keypad will double-beep
3) Test the ramp rate settings by tapping the On/Off buttons on your Keypad or Controller.
Connected lights will ramp up and down at the new rate.
4) Start again if the ramp rate is not as desired or, if your double tap was not fast enough, you may have accidentally
changed the Local On-Level instead of the local ramp rate (note: software allows you to set the on levels and ramp
rates exactly as desired and consistently around the house)
Optional Accessories
For a list of accessories, please visit: http://www.insteon.com/accessories.html