INSTEON Keypad Dimmer (Dual-Band) (2334-2xx US) Manual User Manual
Page 6
Page 6 of 24 Rev: 7/25/2013 9:16 AM
6. Turn breaker(s) off
7. Connect the Line wire and the black
Traveler wire to the black wire on Keypad A with a wire nut
8. Cap the other Traveler wire with a wire nut
9. Cap A’s red wire
10. Connect neutral to A’s white wire
11. Connect Ground to A’s bare copper wire
12. In Keypad B’s junction box, find the Load wire (connects switch to lights, commonly red and will be the only
wire connected to the switch other than the Travelers)
13. Connect the Load wire to B’s red wire
14. In the same junction box, connect the black Traveler wire to B’s black wire
15. Cap the other Traveler wire
16. Connect Neutral to B’s white wire
17. Connect Ground to B’s bare copper wire
18. With button labels right-side up, gently place Keypads into junction boxes and screw in place
19. Turn breaker(s) on
Both Keypads’ LEDs will illuminate.
20. Verify Keypad A is working properly by turning the light on and off
21. Follow steps on Page 8 to cross-link both keypads so that they both control the load
22. Reinstall trim plates
5
If black is not available choose one of the Travelers and make note of its color. Instructions will refer to it as black; if both are black, choose one and use voltmeter to determine which of the
black Travelers in the other junction box you have chosen.