INSTEON Dimmer Module - 2632-422 (France), 2632-432 (Germany), 2632-442 (UK), 2632-522 (AUS/NZ) Manual - Manual (Page 7)

Page 7 of 16 2632-422/2632-432/2632-442/2632-522 - Rev: 1/21/2014 7:46 AM
Note that a link is one way. If you wish to have control “the other way,” simply add a link “the other way.”
Configure INSTEON Settings
Most Dimmer Module links and settings can be configured locally—during installation with the module’s set button or
after installation using the switch connected to the module—or remotely via software (sold separately).
All Dimmer Module settings can be managed remotely via software (sold separately).
Make Dimmer Module a Responder
1) Press and hold controller set button until it beeps
Controller LED will start blinking green
You will have four minutes to complete the next steps before linking mode times out
2) Turn on lamp connected to Dimmer Module and adjust to desired brightness level
3) Press and hold Dimmer Module set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off or pressing and holding to brighten/dim
Lamp connected to Dimmer Module will respond appropriately
Note:
- The link just created is one way. See Make Dimmer Module a Controller or Groups to add another link to
keep the two products in sync.
- If you wish the load to be off when link is activated—such as for an “all off” scene—turn off the load in step
#2.
Make Dimmer Module a Controller
1) Press and hold Dimmer Module set button until it beeps
Dimmer Module LED will start blinking green
You will have four minutes to complete the next steps before linking mode times out
2) Adjust responder to desired state
3) Press and hold responder set button until it double-beeps
Dimmer Module will double-beep and its LED will stop blinking
1
4) Test link by tapping or pressing and holding Dimmer Module paddle to turn on/off or brighten/dim
Responder will respond appropriately
Note:
- The link just created is one way. See Make Dimmer Module a Responder or Groups to add another link to
keep the two products in sync.
- If you wish the load to be off when link is activated—such as for an “all off” scene—turn off the load in step
#2.
1 If either controller or responder LED continues blinking, the addition failed. Tap device’s set button until LED stops blinking and try linking again.
Controller Responder
Link