INSTEON Dimmer Module - 2632-422 (France), 2632-432 (Germany), 2632-442 (UK), 2632-522 (AUS/NZ) Manual - Manual (Page 9)

Page 9 of 16 2632-422/2632-432/2632-442/2632-522 - Rev: 1/21/2014 7:46 AM
Remove Dimmer Module as a Controller
If you no longer want Dimmer Module to control another device (or are removing Dimmer Module from your network)
it is important that you follow the instructions below for each responder.
1) Press and hold Dimmer Module set button until it beeps
LED will start blinking green
2) Press and hold Dimmer Module set button until it beeps a second time
LED will start blinking red
3) Press and hold responder set button until it double-beeps
Dimmer Module will double-beep and LED will stop blinking
4) Test by tapping Dimmer Module on and off
Former responder will not respond
Remove Dimmer Module as a Responder
If you no longer want a controller button to control Dimmer Module, follow these directions.
Note: If you ever wish to uninstall Dimmer Module, it is important that you remove all Dimmer Module responder
links. Otherwise, controllers will repetitively retry commands, creating network delays.
1) Press and hold controller button until it beeps
LED will start blinking green
2) Press and hold controller button until it beeps a second time
LED will start blinking red
3) Press and hold Dimmer Module set button until it double-beeps
Controller LED will stop blinking
4) Test by tapping controller button on and off
Dimmer Module will no longer respond
Remove Dimmer Module as a Controller of Multiple Responders
1) Press and hold Dimmer Module set button until it beeps
LED will start blinking green
2) Press and hold Dimmer Module set button until it beeps a second time
LED will start blinking red
3) Tap Dimmer Module set button
LED will start double-blinking red
4) For each responder you are removing:
a. Press and hold set button until it double-beeps
5) Tap Dimmer Module set button
Dimmer Module will beep and LED will stop blinking
6) Test by tapping Dimmer Module paddle on and off
None of the former responders will respond
Factory Reset
All settings, links and scenes will be erased.
1) Press and hold Dimmer Module set button until it beeps
LED will start blinking green
2) Press and hold Dimmer Module set button until it beeps a second time
LED will start blinking red
3) Press and hold Dimmer Module set button until it beeps a third time
LED will start blinking green
4) Slowly tap Dimmer Module set button three times
LED will start double-blinking green
5) Press and hold Dimmer Module set button. Do not let go.
Dimmer Module will begin to emit a long beep