INSTEON DIN Rail On/Off - 2453-222 (US), 2453-422 (EU), 2453-522 (AUS/NZ) Manual - Manual (Page 11)

Page 11 of 16 2453-222/2453-422/2453-522 - Rev: 1/21/2014 7:51 AM
Load brightness levels 32 locally (256 with software)
LED
Green when load is on, red when load is off.
Blinks red when responder does not acknowledge (can be disabled via
software).
Blinks red or green during setup.
LED brightness Adjustable, from off to bright
Local control Yes
Commands supported as controller On/off, Fast on/off, Begin brighten/dim, End brighten/dim
Commands supported as responder On/off, Fast on/off, Beep
Software configurable Yes
RF range
Up to 150 feet (50 meters) open air*
*Range may vary due to local interference
Phase detect beacon Yes
INSTEON device category 0x02 Switched Lighting Control (all frequencies)
INSTEON device subcategory
US 0x2E
EU 0x33
AUS/NZ 0x34
X10
X10 address 1 optional (comes unassigned)
X10 transmitter Yes
X10 receiver Yes
X10 status response Supported
X10 resume dim Supported (by setting local on-level to zero)
X10 minimum transmit level 3.2 Vpp into 5 Ohms
X10 minimum receive level 20mV into 5 Ohms
X10 messages repeated No
Mechanical
Mounting 35mm (top hat) DIN Rail
Wires NA
Max Cable Size 4mm2, 12 AWG (2.72mm Diameter)
Min Cable Size 1.5mm2, 15 AWG
Screw DIN Rail connections Line, Neutral, Load, Sense 1, Sense 2
Case color White
Set button Yes
Plastic UV stabilized polycarbonate
Beeper Yes
Beep on button press Optional (off by default)
LED 1, RGB
Dimensions 3.14"H x 2.05"W x 2.48"D (80mm x 52mm x 63mm)