Ken Tool T11EH_T11AH_T11KH Handled Bead Breaking Wedges - Manual

HANDLED BEAD BREAKING WEDGE
CAUTION AND INSTRUCTIONS FOR ASSEMBLY
Caution:
Improper use of this tool can cause damage to wheels and or tires.
• Always wear safety goggles.
• Completely deflate the tire and remove the valve core before breaking the
bead.
• The tool blade is to be put in the bead of the tire along the rim of the
wheel.
• The back end of the tool is to be struck with a soft-faced hammer.
• Do not strike the wheel or wheel components with any steel tools.
• This tool is to be used only for breaking tire beads.
• This tool is not intended to be swung.
Slide head over the handle, hold tire
tool by handle (head down) and
strike the head assembly firmly on
the floor to secure it. To disassemble, hold tool by head
(handle down) and strike firmly on
floor.
For T11EH, T11AH, and T11KH Handles
3/02
·
Handles are not interchangeable. Use only the specified replacement handle for the
head being used. Using the wrong handle can cause the locking system to be damaged
and allow the head to fall off the handle.
Note: T11KH handle will only work on T11K head.
Other replacement handles will not work with T11K head.