Ken Tool 33195 Nineteen-Five Mount_Demount Tool Set - Manual

Instruction Manual
©2009 Ken-Tool
Part No. 33195-98
33195 – Nineteen-Five™ Mount/Demount Tool Set
MOUNTING INSTRUCTIONS
Follow Tire and Wheel
Manufacturer’s Instructions
1 2 3
Always use plenty of bead
lubrication on the tire and wheel.
Manually push lower bead over rim
When mounting the top bead, place the bead holder (use #31710 for
steel rims; #33196 (shown) for aluminum rims) on the rim and slide
to one side, as a stop against the bead.
y p
and into position for mounting.
Using the bent end of the
Nineteen-Five tire iron, with stop
resting against the rim, pry the
bottom bead over the rim.
Repeat progressively around tire,
working with small sections, until
th b
d i l t l th
See Video Demo at www.kentool.com
ALWAYS MOUNT WITH
WHEEL HUB SIDE UP!
the bead is completely over the
rim.
6 5 4
Repeat this step, taking small
sections of the bead, until the
last section is pried over the rim
and the tire is mounted The curved end of the tool easily
gets under the stretched bead for
“that last bite”. Stand on the tire and use the
curved end of the tool to pry a
section of the top bead over the
rim
and the tire is mounted. rim.
Press the sidewall of the tire
down, as you work your way
around, to force the top bead into
the drop center of the wheel.
(C)2007 Ken-Tool
768 E. North Street, Akron, Ohio 44305; Phone: 888-536-8665, Fax: 330-535-1345
Website: www.kentool.com E-Mail: [email protected] 1
Bent End
Curved End