Ken Tool 33195 Nineteen-Five Mount_Demount Tool Set - Manual (Page 2)

Instruction Manual
©2009 Ken-Tool
Part No. 33195-98
33195 – Nineteen-Five™ Mount/Demount Tool Set
DEMOUNTING INSTRUCTIONS – First Bead
1 2 3
Break both beads and always use
plenty of bead lubrication on the tire
and wheel. Start by bringing one Nineteen-
Five bar across the center of the
rim. Then cross with the second Once the two bars are crossed,
forming an “X” over the rim, press
down on the two bars. This will
Using two Nineteen-Five bars,
insert the curved end of each bar
between the rim and wheel (about
12 inches apart) with the curve
down.
bar as you move to the opposite
side of the tire/wheel assembly. cause the first bead to demount.
ALWAYS DEMOUNT WITH
WHEEL HUB SIDE UP!
DEMOUNTING INSTRUCTIONS – Second Bead
4 5 6
Lift the assembly as shown to partially
release the wheel from the tire.
Insert the bent end of the tire iron
between the rim and wheel until the
While holding down on the tire,
lift the curved end of the bar to
demount the second bead.
Sometimes it may be necessary
Hold the curved end up as
you lean the assembly toward
you. Allow the wheel to lay flat
in front of you.
between the rim and wheel until the
stop is resting against the rim. Sometimes it may be necessary
to use the second bar, if the tire
is especially tight to pry the tire
off the wheel .
33199
768 E. North Street, Akron, Ohio 44305; Phone: 888-536-8665, Fax: 330-535-1345
Website: www.kentool.com E-Mail: [email protected] 2
33196
31710 31810