King Technology FROG Leap Model 7800 - Manual (Page 14)

14
TOOLS NEEDED
Screwdriver
Pipe Wrench
INCLUDED WITH FROG
Leap Infuzer™
Pipe Thread Tape
or Sealant
One 6” X 1 1/2” TBE PVC
Nipple
MATERIALS NEEDED
One Hose Adapter
1 1/2” X 1 1/2” X 1 1/4”
One Section of
1 1/2” Flex Hose
(provided with filter)
One
Hose Clamp
RECOMMENDED
Corrosion Resistant
Check Valve
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eye ball fittings in the return
jets to a smaller or larger size to
adjust back pressure.
Filter Installation
Apply pipe thread tape or
sealant to each threaded end
of nipple.
Screw one end of nipple
into the filter return. Hand
tighten. Finish tightening by
turning 1 to 2 revolutions
with wrench.
DO NOT OVER TIGHTEN.
1. 2.
Screw either side of
FROG Leap Infuzer™ on
to open nipple end until
upright and secure.
Apply pipe thread tape or
sealant to threaded end
of hose adapter.
3.
4.
Screw adapter into the other
side of FROG Leap Infuzer™.
Hand tighten. Finish tightening
by turning 1 to 2 revolutions
with wrench.
DO NOT OVER TIGHTEN.
5.
6.
Attach return section of hose
to the adapter with clamp.
Tighten clamp with screwdriver.
7.
If using a FROG Leap Torpedo
Pac™, installing a corrosion
resistant check valve is
recommended.