Using frog leap all-out, Using, For a 90-day algae protection guarantee – King Technology FROG Leap Model 7800 User Manual

Page 9

Advertising
background image

9

Using FROG Leap ALL-OUT™

for a 90-Day Algae Protection Guarantee

1.

If you are not using FROG Leap ALL-OUT!™ proceed to inserting
FROG Leap Torpedo Pac™. See FROG Leap ALL-OUT!™ product
labeling for complete directions for use (EPA Reg. No. 53735-9).

For a preventive dose add:
•One FROG Leap ALL-OUT!™ for pools up to 15,000 gallons.
•Two FROG Leap ALL-OUT!™ for pools between 15,000 & 30,000 gallons.

*NOTE:

I

f using directly after a shock treatment, test the water first to ensure the pH is in the proper range of 7.2-7.8 and the chlorine

level is no more than 4.0 ppm. Avoid using other chemicals until this product has been circulated (filtered) for at least 24 hours.

Remove cap from FROG
Leap ALL-OUT!™ without
removing seal.

Insert upside down into
center of FROG Leap Anti-
Bac Mineral Pac™ pushing
down firmly on key to
puncture seal.

Replace cap by hand only.
DO NOT OVER TIGHTEN.

Turn control dial on FROG
Leap Infuzer™ to Setting
5.

2.

3.

4.

5.

Turn pump on for 90 minutes
allowing FROG Leap ALL-OUT!™
to circulate through pool.

6.

To remove FROG Leap ALL-
OUT!™, turn pump off. Turn
dial to Setting 0.

7.

Remove FROG Leap
Infuzer™ cap.

8.

Lift FROG Leap ALL-OUT!™
up and allow any water in the
container to drain through the
FROG Leap Infuzer™ before
discarding in trash.

NOTE: If water shows more
than a hint of blue inside FROG
Leap Infuzer™, replace the
FROG Leap Infuzer™ cap, turn
dial to Setting 5 and run the
pump for one minute.

8a. If pool size requires
additional FROG Leap ALL-
OUT!™, repeat steps 1-8.

8b. When water is clear in
FROG Leap Infuzer™, proceed
to inserting FROG Leap Torpedo
Pac™.

Using

FROG Leap Depth Charge™, FROG Leap Reveille™ or FROG Leap Torpedo Pac™

90-DAY

Advertising