King Technology Perform-Max Feeders - Manual (Page 9)

Above Ground, Filter Installation - Model 920
Apply pipe thread tape or
sealant to each threaded
end of nipple.
Screw one end of nipple
into the filter return.
Screw either side of
Perform-Max on to open
nipple end until upright and
secure
.
Tighten turning
1 to 2 revolutions with wrench.
DO NOT OVER TIGHTEN.
HOSE
ADAPTER
HOSE
ADAPTER
HOSE ADAPTER
9
MATERIALS NEEDED
One
Hose
Clamp
Corrosion Resistant
Check Valve
RECOMMENDED
Finish tightening by turning
1 to 2 revolutions with wrench.
DO NOT OVER TIGHTEN.
4.
5.
6.
1.
2.
3.
7.
Apply pipe thread tape
or sealant to threaded
end of hose adapter.
Screw adapter into open end
of Perform-Max. Hand tighten.
Attach return section of hose to
the adapter with clamp. Tighten
clamp with screwdriver.
TOOLS NEEDED
Screwdriver
Installing a corrosion resistant
check valve is recommended.
Pipe Thread
Tape or
Sealant
One Hose Adapter
1 1/2" x 1 1/2" x 1 1/4"
One 6" x 1 1/2" TBE PVC
Nipple
One Section of
1 1/2" Flex Hose
(provided with filter)
Pipe Wrench