Kolpin 85160 – Kawasaki Swing Arm 2 Receiver Hitch User Manual
Kolpin Hardware
85160 – Kawasaki Swing Arm 2” Receiver Hitch
Hitch Assembly:
1. Using the 5/16” bolts provided, attach the Receiver Hitch Plate to the Right Outer Plate and the
Left Outer Plate, loosely. Do not tighten bolts at this time!
Hitch Mounting:
Note-using a floor jack to lift the rear of the machine will lessen the possibility of leaking rear
axle lube.
1. Remove the 11 bolts that are holding the stock hitch on the ATV. Remove Hitch.
2. Mount hitch (85160) to the same holes that the existing hitch was in and attach using the hardware
provided.
3. Use the 2 existing Bolts to reattach the skid plate with the DirtWorks Hitch.
4. Tighten down the Hitch Tube Weldment to the side plates, making sure that the Hitch is level
while tightening.
Note: It is possible to have rear axle fluid spill out of axle differential during removal and re-installation of
your receiver hitch, if this should occur see owners’ manual for proper fluid type and replace any lost fluid
before use.
Hitch Use:
• The 2” Receiver hitch is designed to allow you to quickly and easily mount and dismount the
DirtWorks 3-Point Hitch system.
• Kolpin recommends the use of the DirtWorks Suspension Lock with the use of the DirtWorks
System.
• The hitch can also be used for chores around the house, such as moving your boats, trailers, etc.
Description Quantity
Left Side Inner Plate
1
Left Side Outer Plate
1
Right Side Inner Plate
1
Right Side Outer Plate
1
Receiver Hitch Plate
1
5/16” x 1 1/2” Grade 8 Bolts
6
5/16” Grade 8 Nylock Nut
6
5/16’ Flat Washer
6
10mm X 40mm x 1.25 pitch Flanged Bolt
6
8mm X 35mm x 1.25 pitch Flanged Bolt
3
5/8” x 3” Bent Hitch Pin
1
R-Pin 1
Instruction Manual
1