Controlled Products Systems Group AOMSL100 - Manual (Page 21)

ON
514
GDE
ON
514
GDE
ON
514
GDE
ON
514
GDE
ON
514
GDE
ON
514
GDE
MASTER/SLAVE CONNECTION
Use a two wire and run it through a UL listed conduit for master/slave connection.
Follow the wiring diagram as shown below.
shielded cable
Master Board Slave Board
+.....................Positive to Positive...................+
-...................Negative to Negative...................-
Before connecting master/slave gate operators together, test and adjust limit switches and the ERDs
for each operator as “ ” machines. All accessories must be installed on the master board, no
exception.
the
stand alone
See page 49 for dip switch settings.
Connect shield to
slave metal frame
only.
Use UL listed
conduit
Shielded
cable
39