Controlled Products Systems Group SW4705011G3 - Manual (Page 14)

14
WARNING
CAUTION
WARNING
WARNING
DISCONNECT POWER AT THE FUSE BOX BEFORE
PROCEEDING.
OPERATOR MUST BE PROPERLY GROUNDED AND
CONNECTED IN ACCORDANCE WITH LOCAL ELEC-
TRICAL CODES. NOTE: THE OPERATOR SHOULD
BE ON A SEPARATE FUSED LINE OF ADEQUATE
CAPACITY.
ALL ELECTRICAL CONNECTIONS MUST BE MADE
BY A QUALIFIED INDIVIDUAL.
INSTALL POWER WIRING & CONTROL STATION
WARNING
CAUTION
WARNING
WARNING
ANY MAINTENANCE TO THE OPERATOR OR IN THE
AREA NEAR THE OPERATOR MUST NOT BE PER-
FORMED UNTIL DISCONNECTING THE ELECTRICAL
POWER AND LOCKING-OUT THE POWER VIA THE
OPERATOR POWER SWITCH. UPON COMPLETION
OF MAINTENANCE THE AREA MUST BE CLEARED
AND SECURED, AT THAT TIME THE UNIT MAY BE
RETURNED TO SERVICE.
NOTE: Calculated using NEC guidelines. Local codes and conditions must be reviewed for suitability of wire installation.
NOTE: All power wiring should be dedicated and protected. Location of primary power disconnect should be
labeled.
WARNING
CAUTION
WARNING
WARNING
DO NOT INSTALL ANY WIRING OR ATTEMPT TO
RUN THE OPERATOR WITHOUT CONSULTING THE
WIRING DIAGRAM. WE RECOMMEND THAT YOU
INSTALL AN OPTIONAL REVERSING EDGE BEFORE
PROCEEDING WITH THE CONTROL STATION
INSTALLATION.
WARNING
CAUTION
WARNING
WARNING
BEFORE INSTALLING POWER WIRING OR CON-
TROL STATIONS BE SURE TO FOLLOW ALL SPECI-
FICATIONS AND WARNINGS DESCRIBED BELOW.
FAILURE TO DO SO MAY RESULT IN SEVERE
INJURY TO PERSONS AND/OR DAMAGE TO OPER-
ATOR.
6
8
10
12
1/2
3/4
1
1/2
3/4
1
1/2
3/4
1
1/2
3/4
1
425
291
213
269
183
134
168
115
84
105
72
53
1845
1107
852
1165
699
537
730
438
337
458
274
211
2557
1827
1278
1614
1152
807
1012
723
506
634
503
316
12789
6394
5115
8072
4035
3228
5064
2532
2025
3171
1585
1269
15987
10657
7993
10089
6726
5044
6330
4220
3165
3964
2643
1982
THREE PHASE SINGLE PHASE
WIRE LENGTH IN FEET (STRANDED COPPER WIRE)
WIRING SPECIFICATIONS
WIRE GA. HP
ON A DUAL GATE SYSTEM EACH UNIT MUST BE INSTALLED ON ITS OWN SEPARATE CIRCUITS
115 VAC 230 VAC 230 VAC 460 VAC 575 VAC