Level Mount DCDSK30SJ - Manual (Page 7)

7
www.levelmount.com
1-888-229-1459
EU: +0044 844 567 2657
UK: 0844 567 2657
©2011 Level Mount - Patents Pending
Figure 12
Desk Top
Desk Top
Arm
Arm Plate
Monitor
Bracket
Monitor Cord
Management
Bubble
Level
Desk
Desk Top
Arm
Monitor
Bracket
Desk
onitor
acket
Figure 13
Arm
Plate
Monitor
Assembly/Installation
Step 5 – Organizing Monitor Cords
To organize and hide the Flat Panel Monitor’s cords, slide the bottom two
sections of Cord Cover down off the back of the Desktop Arm as shown in
Figure 14 (The top section remains in place). Feed the cords from the Flat Panel
Monitor into the hollow of the Desk Top Arm. When cords are in place, slide the
two sections previously removed back up into the channels of the Desk Top
Arm, starting with the cut-out scoop then the straight section. Push up until the
cut-out section meets the top section of Cord Cover.
Figure 14
Cord Cover
Cord Cover
Desk Top Arm
Cords
L-Bracket
Cord Cover
Cord Cover
Sections
Cord
Management
Built-in Bubble Built-in Bubble
Level/ Level/
Spirit Level p p
Figure 11
Arm
Plate
Step 4 – (Continued)
The Arm Plate has a Built-in Bubble Level/Spirit Level to ensure the Flat Panel
Monitor is level when attached to the Desktop Arm. The Cord Management
hook at the bottom of the Arm Plate, gathers the cords from the Flat Panel
Monitor to feed through the Cord Cover as shown in Figure 11.
Lift the Flat Panel Monitor with the Flat Panel Bracket attached, higher than
the Arm Plate, which is attached to the Desktop Arm. Place the back of the
Flat Panel Bracket over the Arm Plate and slide the Flat Panel Bracket down
until it clicks together with the Arm Plate as shown in Figure 12.
The Flat Panel Bracket secured to the Arm Plate and Desktop Arm appears as
shown in Figure 13.