Fig. 4.1 – Magnum Venus Plastech System One FRP 4101-00-01 User Manual
Page 10
FRP SystemOne
Gelcoat
7
Fig. 4.1
Offeset intake and outlet
ports one flat hex as
shown in figure.
14. Install the 7304-2-1 (Piston Seal) onto the threaded end of the
4101-4-1 (Piston Body) spring side up.
15. Install the 4101-5-1 (Piston Guide) onto the 4101-4-1 (Piston Body)
below the 7304-2-1 (Piston Seal).
16. Screw the 4101-6-1 (Seal Retainer) onto the 4101-4-1 (Piston
Body), hand tight.
17. Hold the 4101-10-1 (Piston Rod) with a wrench on the wrench
flats, and tighten the 4101-6-1 (Seal Retainer) with another
wrench.
18. Insert the Piston Rod assembly into the 4101-2-1 (Cylinder) s
crewing the 4101-14-1 (Outlet Body) onto the cylinder threads.
19. Align the 4101-14-1 (Outlet Body) so the outlet port is one hex flate
to the left of the inlet port of the 4101-7-1 (Inlet Body) See Fig. 4.1
NOTE
Note orientation of seal on drawing.
NOTE
Screw the Outlet body down until you feel the O-Ring start to
compress.