Magnum Venus Plastech PATRIOT Duo 1:1 DUO-PAT-7-12-SIL - Manual (Page 15)

Patriot Duo Unit Manual
Rev. 07/2012 Page | 15
Introduction:
The Patriot Duo 1:1 Unit comes in two configurations Spatter and Pour. Most of the
procedures will be the same between the two configurations but any differences will be
noted.
This manual provides information needed to properly operate and perform simple
maintenance and repair on this equipment.
Step-by-step operations procedures are provided.
This manual includes Installation, Start-up and Shut-Down instructions.
Step-by-step assembly and disassembly procedures are included for each
component.
Please read this manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
Major Components:
The Patriot Duo 1:1 Unit consists of the following major components:
Duo Patriot – Fluid Sections (PAT-LS-12770-D)
7” Patriot Power Head – Duo Pump (PAT-PH-7000-D)
Classic Pro DUO Gun – Spatter (CPD-5000-SNZ)
Description of Controls for Unit:
Familiarize yourself with the Air Manifold controls, which consist of the following
regulators and gauges:
PUMP PRESSURE gauge and regulator. This controls the main air pressure to
the resin pump Air Motor.
PRIMING BUTTON push button control. This control allows the pump to operate
with out opening the gun. The Priming Button sends an air signal to the pump
control valve which allows control air to the power head.
MAIN AIR INLET VALVE – This is the main air inlet ball valve. This ball valve is
used to turn off air supply to the unit. It also releases the air pressure in the unit.
Note: Open the Main Air Ball Valve in one full stroke open or closed if partially
opened air will leak from the exhaust port on the valve.