AT&T 1480 - Manual (Page 18)

15
TELEPHONE DIRECTORY
AT THE BASE OR HANDSET
4 When you finish entering the name, press
S.
The screen displays ENTER NUMBER.
5 Enter the telephone number. Use
< to backspace and make
a correction. Press
r to store a pause in the dialing
sequence.
—OR—
Press
r to display the last number dialed from
this phone.
6 Press
S. If you are using the base, you are now done. If you
are using the handset, the screen displays DISTINCT RING? and
the current setting.
7 Press
< or > to change the setting. Choose Y (for Yes) if you
wish the phone to alert you to calls from this number by changing
to a distinctive ringing pattern after the first ring. Choose N (for
NO) for a normal ringing pattern.
8 Press
S to confirm your selection. If you chose Y in Step 7, a
D will be displayed with the directory entry.
Note: When memory is full the screen displays MEMORY FULL, an error
tone sounds, and you will not be able to store a new number until you
delete a stored number.
Edit a Number/Name Stored in the Directory
1 Press
> (DIR). The screen displays DIRECTORY.
2 Press
< or > to scroll alphabetically through entries
stored in memory
—OR—
Press the dial pad key for the first letter of the entry you
want to edit.
3 When the screen displays the number you want to edit, press
S. Then press < or > until EDIT flashes.
4 Press
S. The screen displays the name and number. The
flashing cursor appears at the end of the name. Use
<, > and
the dial pad keys to edit the name. Press
S to move on to
edit the number. Press
S to move to edit the Distinctive
Ring setting.
5 Press
S to save the edited information.
E ED DI IT T DIAL ERASE
973-555-0123
1480_book_1ATT 2/25 2/25/02 10:30 AM Page 15