AT&T 1480 - Manual (Page 25)

22
ANSWERING SYSTEM OPERATION
AT THE BASE
Answering System Feature Setup
You can set up one feature at a time, or you can set up a feature and then
move on to set up another feature.
1 Make sure the answering system is on.
2 Press and release
U until you hear the system announce the
feature you want to set. Refer to the “Feature Summary” below for a
description of the features and your choices.
3 Press
c to hear the feature’s settings.
4 Press
t to confirm your selection.
Feature Summary
Default settings indicated by * .
System announces: Description/directions:
“Change remote access code” Set the remote access code you will use
19 * to access features and functions of the
answering system from a touch tone phone.
“Change clock” Set the clock: After you set the day, repeat
Steps 3 and 4 in “Answering System
Feature Setup” to set hours and minutes.
“Change message alert” When Message Alert is turned on, the base
Off * beeps once every 10 seconds when new
On messages have been received.
“Change announce only” When you turn Announce Only on, callers
Off * hear your announcement, but cannot
On leave a message.
“Change call screening” When call screening is turned on, you
On * can monitor both the incoming message
Off and anyone who answers the call at
another extension.
“Change number of rings” Choose how many times the phone will
2 ring before the system answers a call.
4 * With Toll Saver active, the system answers
6 after two rings when you have new
Toll Saver messages and after four rings when you
have no new messages.
NOTE: Exit Feature Setup at any time by pressing an MBOX/STOP button.
1480_book_1ATT 2/25 2/25/02 10:30 AM Page 22