Magnum Venus Plastech Pro Series 11:1 PRO PUMP VPRO-45110 - Manual (Page 13)

13
Pro Pump
NOTE: Flushing the pump fluid section with solvent will make it easier to clean and
rebuild.
CAUTION: There are two (2) hard chrome balls in the Pro 11:1 pump assembly. If a
ball drops to the floor, it will be damaged. (Even if it appears undamaged, it will
contain dents and scratches that will create problems.) Damaged balls must be
replaced or the pump will not work properly.
NOTE: When disassembling the Pro pump assembly, replace any O-Rings that you
expose.
Maintenance:
1. For a complete maintenance schedule, please refer to Chapter 3: Maintenance.
Troubleshooting:
1. For a complete troubleshooting schedule, please refer to Chapter 7:
Troubleshooting Chart.
Parts Drawings:
1. To perform service and repair on the Pro pump assembly, please follow the
procedures below. Please refer to:
Drawing VPRO-45110 – Pro Pump Assembly
Drawing VPRO-2000 – Shift Block Assembly
Drawing 85805-1
– Pro Series Resin Pump Assembly
CHAPTER
4