Magnum Venus Plastech Pro Series 11:1 PRO PUMP VPRO-45110 - Manual (Page 9)

9
MAINTENANCE:
DANGER: Contaminated catalyst may cause FIRE or EXPLOSION. Before working on
the catalyst pump or catalyst accumulator, wash hands and tools thoroughly. Be
sure work area is free of dirt, grease or resin. Clean catalyst system components with
clean water only.
DANGER: FLUIDS UNDER HIGH PRESSURE. Before performing any service and
repair on this equipment, be sure to relieve air and fluid pressure.
DANGER: Always wear appropriate eye protection when working with this
equipment.
WARNING: When removing hoses, place a rag over the hose before loosening it.
Performing proper maintenance at the recommended time intervals maximizes your
equipment’s productivity and efficiency. This section describes recommended maintenance
procedures to be performed daily, weekly, monthly, every three months, twice per year and
once per year.
Please follow the maintenance schedules recommended in this manual. This schedule is
based on a one-shift, 5-day work week, using standard general purpose resin. An idle unit
left with resin in it requires more frequent parts replacement.
DAILY MAINTENANCE CHECKLIST
PART PROCEDURE
Air Filter (“Water Trap”)
Drain the air filter by holding a container under the filter
and turning the valve at the bottom.
Hoses Check for kinks or leaks.
Pro Pump Check the oil reservoir and add oil if needed.
Nozzle Cap Coat nozzle cap and threads with Red Grease.
Materials
Check and fill catalyst jug and gel coat / resin. Never
run out
CHAPTER
3