Magnum Venus Plastech Pro Series 11:1 PRO PUMP VPRO-45110 - Manual (Page 34)

34
Danger: To prevent injury, always relieve pressure before attempting to remove components.
Danger: To prevent injury, always relieve pressure before attempting to remove components.
Danger: To prevent injury, always relieve pressure before attempting to remove components.
Actuator valve or socket cap Replace the broken cartridge
screw at shift block broken. valve or socket cap screw. See
Chapter 6: Pro Pump.
Pro pump or hose plugged. Disassemble and clean Pro
pump. Replace any worn parts.
Replace hose as required.
Air not connected. Check that air hose is connected
at manifold, and regulator is at
20psi or more.
Air restricted. Straighten any kinks in air hoses.
Pro pump not primed. Check all connections between
pump and end of pick-up wand
for leaks. Prime resin system.
Material in oil well Packing worn. Replace packing set in lower
part of the pump. See Chapter
4: Pro Pump.
Piston rod worn or scored. Replace piston rod. See
Chapter 4: Pro Pump.
No resin or gel coat delivery Foot valve, spring retainer, or Clean or replace foot valve,
on down stroke foot valve ball damaged or dirty. spring retainer, and foot valve
ball. Be sure to lubricate ball
thoroughly with Red Grease.
See Chapter 4: Pro Pump.
Hose leaks at fittings Fitting loose. Tighten fitting. Check all fittings
for leaks before operating.
Fitting or nipple damaged. Replace damaged parts.
Crimped hose. If the hose has been sharply
bent, the plastic liner may be
ruptured. Remove and replace
hose.
Danger: To prevent injury, always wear eye protection and follow safety guidelines provided
by your materials manufacturer.