Luminex 200 Installation Guide - Manual (Page 36)

7. Attach the power cord to the power input module of the Luminex XYP instrument and
attach the serial cable to the Luminex XYP instrument. Do not plug the Luminex XYP
instrument into the power outlet.
NOTE: The cable that connects the analyzer to the PC is 5 feet long; the
cable that connects the SD to the analyzer is 2.5 feet long.
8. Attach the power cord to the input module of the Luminex 200 analyzer, then attach the
USB cable (PN 85-10011-00-046) to P1 on the analyzer. Do not plug the power cord into
the power outlet. See the Luminex 200 Connections image below. Device disconnects
for the Luminex 200, Luminex XYP, and the Luminex SD are the power cords. Do not
position these devices such that it is difficult to operate the disconnect device.
9. Connect the Luminex 200 analyzer USB cable and the Luminex XYP instrument serial
cable to the PC. See callouts 11 and 13 in the Luminex 200 Connections inage below.
10. Connect the barcode reader USB cable, keyboard USB cable and mouse USB cable to
the PC. Ensure that the barcode reader USB is not plugged into a USB port that is
directly adjacent to the Luminex 200 analyzer USB cable.
11. Plug the Luminex XYP instrument, Luminex 200 analyzer, PC, and monitor power cords
into approved outlets. We strongly recommend using an uninterruptible power supply
(UPS) to protect the system from power variations. Choose one that can provide 1050
Watts for at least 45 minutes. The UPS should be UL listed (or equivalent), CSA certified,
and CE marked when used internationally.
FIGURE 11. Luminex 200 Connections (Luminex 200 Analyzer,
Luminex XYP Instrument, and PC)
1 USB Communication Cable (P1) 8 SD Cable (P2)
2 Luminex XYP Instrument 9 PC Power Cable
3 Luminex XYP Instrument to PC Serial
Cable 10 USB ports
4 Power Cords 11 Monitor cable port
5 Luminex XYP Instrument Power Switch 12 Luminex XYP port
6 Luminex 200 Analyzer Power Switch 13 Printer cable port
7 Luminex 200 analyzer
In Vitro Diagnostic Use Luminex 200 System Setup
25