Max Machinery G240 Gear Flow Meter - Manual (Page 13)

Max Machinery, Inc. G Series User Manual © Copyright 2013 Rev. 001Q4
Frequency
Single Phase
Wiring
PCA label Mating Cable
Wire Color
Turck
Pin #
Case Ground Case Blue 3
Common Com Black 4
Power 5-26 Vdc V+ Brown 1
Pulse Output Ph A White 2
N/A NC Grey 5
Frequency
Single Phase
* A current sinking device produces an output pulse which is the opposite of a sourcing device.
A positive DC voltage must be applied to the wire running between PhA and your PLC. When the
output is triggered, this voltage will be grounded to zero volts. Note: use a 5k ohms resistor to limit
the current flow in the signal line.
Current Sinking* Wiring
(models 29X-6XX)
PLC
Digital
Input
V+
V+
Out
0V
Transmitter
Turck Pin #2
PCA label Mating Cable
Wire Color
Turck
Pin #
Case Ground Case Blue 3
Common Com Black 4
Power 5-26 Vdc V+ Brown 1
Output Phase A Ph A White 2
Output Phase B Ph B Grey 5
Frequency
Quadrature
Electrical Installation - Wiring
Wiring FREQUENCY
The electrical connector versions are pre-wired inside the transmitter and ready to accept a mating cable (available from
the factory). The liquid-tight, NPT models need to be wired during installation as shown in the table below:
Turck Connector
2 1
4
5
3
(Brown)
(Black)
(Grey)
(White)
(Blue)
Wiring Diagram
(Brown)
(Black)
(Grey)
(White)
(Blue)
Freq
V+
Com
PhA
PhB
Case
Analog
V+
Com
Sig
Ret
Case
Model 295/296
* *
*Serial interface receptacle.