Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Installation User Manual

Page 33

Advertising
background image

3.2.2 DISPLAYING A DATAPOINT

The following procedure illustrates how to display the contents of datapoint B012, which is the dis-
play brightness index.Note that

B12 is shown being entered instead of B012 , since leading zeros

are not required when specifying datapoints.

3.2.2.1 Procedure to Display a Datapoint

•

Press the Mode button to enter the ENGINEER
mode indicated by the appearance of either CONFIG-
URE
, DISPLAY or PROGRAM at the bottom of the
display.

•

If DISPLAY does not appear, press F2 until DISPLAY
appears

•

When DISPLAY appears at the bottom, press F3.

•

Press F2 until DATAPOINT appears at the bottom of
the display.

•

The bottom of the screen should appear as shown on
the right.

•

Press F3 to enter DATAPOINT mode.

MODULAR CONTROLLER QUICK START

3-8

Advertising