Micromod MOD: 1750N Output holder for MOD 30ML - Manual (Page 12)

Output Holder Instructions
MECHANICAL INSTALLATION
• The panel provides rigid support for a fully loaded 5.5-pound (2.5 kg) controller and any
other panel devices.
• Electrical wiring routing and support are planned.
Mount the output holder as follows:
1. Prepare the panel as indicated in Figure 2-1.
2. Slide instrument into panel cutout.
3. Insert brackets into slots in top and bottom of instrument housing.
4. Tighten retaining screws to a torque of 5 inch-pounds (0.6 Nm) or 1-1/2 turns after
contact is made with the back of the panel.
MOUNTING DIMENSIONS
Figure 2 .1. Output Holder Mounting Dimensions
2 -2