Minuteman E Ride 21 - Manual (Page 30)

5-2
5.2 SQUEEGEE CLEANING
1. If necessary, remove the squeegee (See procedure
in the related paragraph).
2. Wash and clean the squeegee (1, Figure 5-1); in
particular, clean the dirt and debris in the spaces (2)
and hole (3). Check that the front rubber blade (4)
and the rear rubber blade (5) are whole and do not
show cuts or tears, otherwise replace them (see
procedure in the related paragraph).
3. If removed, replace the squeegee (See procedure in
the related paragraph).
Figure 5-1
NOTE
To obtain a good floor drying, the squeegee
must be cleaned and the rubber blades must
be in good conditions.
ATTENTION!
The use of work gloves is recommended
during the squeegee cleaning due to the
possible presence of sharp debris.
2 2 5
1
3
4 1