Minuteman E Ride 21 - Manual (Page 44)

5-16
5.14 ASSEMBLY-DISASSEMBLY OF THE
DISC BRUSH
Disassembly
1.
Ascertain that the wash-and-dry machine cannot
move autonomously.
2. Sit on the wash-and-dry machine seat and rotate the
ignition key (1, Figure 5-16) on “I”, then wait for a few
seconds so that on the display (3) appears caption (4)
“READY” indicating that the wash-and-dry machine is
ready for use.
3. Press the button (5, Figure 5-16) to release the brush
and wait for a few seconds that the wash-and-dry
machine releases the brush after activating it.
4. Rotate the ignition key (1, Figure 5-16) on “0” and
then extract it.
5. Move slightly the squeegee (6, Figure 5-16) and
recover the disc brush (7).
Assembly
6.
Ascertain that ignition key (1, Figure 5-16) is on “0”.
7. Ascertain that the coupling hub of the disc brush is in
the raised position.
8. Place the disc brush (7, Figure 5-16) below the
wash-and-dry machine, by centring it on the coupling
hub.
9. Sit on the seat and rotate the ignition key (1,
Figure 5-16) on “I”, and wait for a few seconds so
that on the display (3) appears caption (4) “READY”
indicating that the wash-and-dry machine is ready for
use.
10. Press the brush lowering and rotation (8, Figure 5-
16) activation button.
11. Press slightly and only for an instant the pedal (2, Fig.
R), by determining the lowering of the hub that will
couple the brush.
In case of non-coupling of the brush, get out of the
wash-and-dry machine and reposition the brush on
the coupling hub which will have remained lowered
(therefore, the alignment operation will be facilitated).
12. Repeat the operations described in the previous
points 9, 10 and 11.
13. Rotate the ignition key (1, Figure 5-16) on “0” and
then extract it.
Figure 5-16
8
4
5
3
1
6
2
7