Remove the filter from its seat (4), Clean the nozzle (2) and the filter (4), Replace the filter correctly (4) in its case – Minuteman E Ride 21 User Manual
Page 37: Figure 5-9
5-9
5.9
CLEANING THE NOZZLE AND FILTER
DETERGENT SOLUTION SUPPLY TO
THE CYLINDRICAL BRUSHES
1.
Ascertain that the wash-and-dry machine cannot
move autonomously.
2.
By acting on the wash-and-dry machine controls,
lower the cylindrical brushes, then rotate the ignition
key on “0” and extract it (see chapter Use).
3.
By acting on the front part of the cylindrical brush-
holder head, unscrew the ring nut (1, Figure 5-9) and
recover the nozzle (2) and the gasket (3).
4.
Remove the filter from its seat (4).
5.
Clean the nozzle (2) and the filter (4).
6.
Replace the filter correctly (4) in its case.
7.
Place the nozzle (2) and the gasket (3) in their seat
and then screw the ring nut (1).
8.
Rotate the ignition key on “I” and wait for the lifting of
the cylindrical brushes, then rotate the ignition key on
“0” and extract it.
5.10
CLEANING THE DETERGENT
FEEDING SYSTEM (OPTIONAL)
1.
Empty and clean the washing detergent tank, by
acting as described in the related paragraph.
2.
Put about one litre of clean water into the washing
detergent tank.
3.
Use the wash-and-dry machine by simulating the
washing activity, for the time necessary to clean the
detergent feeding system (15-30 minutes), by
adjusting the clean water and “detergent” flows to the
maximum values.
4.
Finally, remove the residual water from the washing
detergent tank.
5.
If necessary, perform the other intended procedures
“After use of the wash-and-dry machine” (See the
related paragraph).
Figure 5-9
2
1
3
4
1